So with your rod go to the center of your awning and you should see a strap.
Using syraps to secure trailer awning.
With the cam locks and the travel locks undone you can now go ahead and open the awning.
Ratchet straps ratchet straps are another diy solution for anchoring your electric awning.
To ensure that your awning is as secure as possible before a storm we recommend that you read these five specific tips on what to do before a storm hits.
Purchase the storm proofing kit for both corners and the middle if you have the penta model you will need to buy five sets.
Grab the strap with your rod and pull it right out.
The camco awning de flapper max works by clipping 8 wide grippers to your awning then uses velcro like hook and loop fastener straps to attach the gadgets to the side awning arms to prevent flapping in windy and rainy conditions.
Camco awning de flapper max protects your rv awning from costly rips and tears rust resistant.
Make the straps tight but not so tight that it damages the awning arms.
Using the awning rod hook it into the pull strap that is found in the center of the awning.
If your torsion spring is correctly wound then you shouldn t need to much force to open the awning.
Pull it all the way out until you see the valance about 90 degrees to the ground.
Video of how to install and tie the corkscrews off.
These sturdy straps could provide a stronger hold for your awning than the straps that come with anchoring kits.
However it is important that you do not tighten the straps too tight or else you will bend and damage your awning.
X2 on the cork screws.
You can buy awning straps that anchor to the ground at any rv store or online or just get 2 of the corkscrew type anchors used for securing dog leashes and some rope or a ratchet strap.
Even after securing your rv awning against the wind a large gust can still damage it.
Using ratchet straps and stakes secure each corner of your awning to the ground.
How do i storm secure my awning.