First hold your lift cords level with the headrail and gently pull.
Venetian blind cord lock stuck.
If that still doesn t work you can manually disengage the cord lock.
Untie or cut off knots at ends of tilt cord and remove pulls.
Lift up and out depending on your bracket configuration to remove the blinds from the window.
Pull the cord toward you and cut the knot off the end of the cord.
If the cords still don t pull or adjust the height of your blinds then you may need to force the lock mechanism open.
If the lock malfunctions the cord and blinds will become stuck in the raised position.
Place the screwdriver head in a perpendicular position to the head rail and press the flat surface against the pin.
If this does not fix the problem take your blind out of the window.
It doesn t connect with lift cord.
You can do this with your hands and fingers.
Use these directions to replace a tilted cord.
To release the blinds tug the lift cords to the side pulling towards the center of the blinds.
It has the blind s cords running through it.
Sometimes the cord can become lopsided or tilted after extensive use and affect how the blind functions.
Step 3 if the cords are stuck or jammed take a screwdriver or needle nose pliers and move the pin to free the cords.
Use the flathead screwdriver to poke the pin inside the lock mechanism.
Grasp the side cord on the blinds and raise it upward until it is level with the top rail on the blinds.
Remove old tilt cord by pulling it out.
Tilt cord is simply threaded over pulley and out again.
When tugging the cords to the center of the blinds doesn t lower the blinds remove the blinds from the brackets.
If this does not work the pawl must be released follow these easy steps.
This should release the cord lock.
Remove the cap covering the hole in the bottom rail of the venetian blinds.
This pin holds the lock.
Lift the bottom of your blinds even if they are already stuck at the top near the headrail.
This occurs for a variety of reasons but you can typically lower the blinds using a manual method.
Step 2 make sure that the cords can move freely.
Set the blinds on a tabletop or countertop so that the lock mechanism with the open top of the head rail is accessible.
Look inside the head rail to find the lock mechanism.
Take a screw driver and press the pawl down in the track in which it travels.
Step 1 take a look at the cords and moveable pin in the cordlock mechanismlocated inside the headrail of the blind.
To do this carefully remove the blind from the window and lay it on a flat surface.
Locate the cord lock mechanism in the headrail the lift cords run through this.
It s important to have properly working cords on a venetian blind.
Look for the end of the cord where it is tied in a knot.
